Not a chance :>). Not an oversight. Deliberate choice. Turning a rig off/on is supposed to reset everything except configuration settings and start it over after such things as power spikes, yada, yada. Having test mode persist across power cycles would create a lot of confusion. Same kind of angst as having a firmware update hang before completion.
Test mode is and always has been TEMPORARY. If you want your no power out to persist, then turn PWR level to zero. That will persist. g. On Thu, Aug 11, 2016 at 11:25 AM, brian <[email protected]> wrote: > I wonder if this is an oversight or difficult to implement? > The potential $$ it could save are large. > > 73 de Brian/K3KO > > On 8/11/2016 15:12 PM, Don Wilhelm wrote: > >> Brian, >> >> Yes, TX TEST will not survive a power cycle. >> >> 73, >> Don W3FPR >> >> On 8/11/2016 10:59 AM, brian wrote: >> >>> Recently I was doing something requiring that K3 not transmit power. >>> TX test was selected. >>> >>> I expected that it would retain this setting after shutdown and >>> subsequent restart. >>> >>> It does NOT stick with a K3 S/N 8XXX and FW 5.38. >>> >>> >> ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
