Hi Gang.... I have a question.... I need to eventually replace my BNC connector on my KX1. Since I did not build the KX1 I have I need some info. I have heard it is difficult to remove the present one because of heat needed to remove the connector. The fear is that the board will be damaged. I have had the KX1 apart down to the main board and I see a phillips screw and I presume that is the screw holding the board in place. Am I correct? I need to remove the board to get to the connecor. What is the best way to remove the BNC connector? Thanks you for your suggestions..
Paul, KD3JF EX: WA4JGI, WA8TER Central Maryland FM19qd (Map Grid Square) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
