The commands are being sent too close together. Place a minimum 100ms delay between the SWH16 and following DS command. Do not send any other commands until after second SWH16.
Four macros were setup to allow “manual” delay between commands. I don’t see a direct way to allow a command-command delay in the command tester. Reducing the baud rate may help. Macro 1 FA;DS; Macro 2 DS; Macro 3 SWH16; Macro 4 DS;DS;DS; The following results were realized: FA;DS; FA00007123610;DS@7±23¶1@;SWH16; DS; DS@@@@1³>I;DS; DS@@@@1³>I;DS; DS@@@@1³>I;SWH16; FA;DS; FA00007123610;DS@7±23¶1@; DS@7±23¶1@;SWH16; DS;DS;DS; DS@@@@1³>I;DS@@@@1³>I;DS@@@@1³>I;DS; DS@@@@1³>I;SWH16; The SWR returned is 1.3-1 as displayed on VFO-A. The @ in the returned data means there is NO data in that byte position. The returned DS data will require “massaging” to get a proper text string as there is display Icon data mixed in. A KX2 was used for this test, but KX3 should be the same. de Ben W4SC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
