Hi, My K2/10 has an occasional bout with popping static that comes on for a minute or so, attenuates the receive signal while it is happening, then goes away. Might come back again in a couple minutes, or not. Was wondering if anyone has chased down a problem like this in theirs. Radio was recently looked at, configured and aligned. Didn't have any problems after it's checkup, until a few days later. Radio has kat2, knb2, kio2, k160RX, ksb2, and kaf2 options installed. It did have the kbt2 installed, but I felt it was in the way, so I removed it before the last time it went in for a check up. The cure is to turn off radio, wait a few seconds, turn on again. Does not matter the power setting or band or filters engaged, will still happen. Steve/KI4EZL
Thank you, Steve ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
