Cary, I don't have any really good ideas about what may be wrong (other than to simply say "its broke" <G>), but I suggest that you turn the manual to Appendix E and follow the steps outlined in the Receiver Signal Tracing section.
As another alternative, you can try the "Cheap and Dirty Signal Tracing" that Tom Hammond has advocated - the document is on the Elecraft website under Builder Resources - then look at Troubleshooting Tips. Once you localize the area of failure, we can help further in isolating it to the failing component. 73, Don W3FPR > -----Original Message----- > > K2 #5266 was playing beautifully on cw and I aligned the filters last > night for SSB, had no problems with that alignment. When I finished, I > found my K2 deaf on ALL bands (it transmits just fine!)...The RANT is > OFF, I have good tone with the SPOT feature (yes, I went through the > troubleshooting steps), even went so far as to do a reset...nothing > restored my K2's ears. Oh, yes, the antenna jack is connected to the > 135' dipole and not the dummy load. > > I'm hoping its something really simple but at this point (actually at > 1:30am), I'm mighty frustrated. > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
