Have a rat shack mike with only 2 wires , an audio and ground wire.
According to mic schematic the on / off switch is parallel to the audio and
the on / off is a slide switch inside the mic.
Currently have the mic audio to pin 1 and mic ground to pins 7 and 8 at the
mic connector. I know in this configuration
there is not PTT wired. I assume I need to wire Pins 1 and 2 together at the
mic connector to get a PTT connection
to P1. What jumper settings on P1 should get this configuration to work ?
Tried several and no luck yet on any setting.
Glenn
K2 4869
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
