Thanks Don.... I took a look and I've got the cables all right. But, Dick at
elecraft suggested I look at communication speed that I had n1mm+ set at and
set it to 38,400 and that took care of it.
Thanks for the answers and hope this helps someone else as well. Gary SlagelAce
Hardware #14814207 So ChicagoHot Springs, SD 57747(605) 890-2310KT0A
From: Don Wilhelm <[email protected]>
To: Gary Slagel <[email protected]>; [email protected]
Sent: Monday, October 3, 2016 4:17 PM
Subject: Re: [Elecraft] kxpa100 computer interface
Gary,
You did not specify the cable connections that you are using. You
should have the KXPACBL for best integration with the KX3. See pages 14
and 15 of the KXPA100 manual.
If you do have those cables and have them connected correctly, then I
would say that you have a problem with the KXPA100 and that you should
contact Elecraft support.
73,
Don W3FPR
On 10/3/2016 5:53 PM, Gary Slagel via Elecraft wrote:
> I'd like to be able to use my kx3/kxpa100 along with my k3 for so2r. I've
> got n1mm+ talking to both the k3 and the kx3 and I can even talk to the kx3
> through the kxpa100 connection. However, I can only talk to the kx3 through
> the kxpa100 connection when the kxpa100 is off! This kind of defeats the
> purpose of having the kxpa100. Is there a solution to this problem?
>
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
