I just updated my firmware after being off the air for a long time. I used to save two frequencies in a memory...like 20m QRP and I would put CW in VFO A and SSB in VFOB.
For some reason, when I load a memory now, it does not update VFO B. When I read the memories from the K3 using the memory management software, it shows the correct VFO B frequency and mode. However, if I save a new memory on the K3 and read it with the software, VFO B is set to the same settings as VFO B. Did this functionality quietly get stripped to scavenge more memory for other functions? Jim W6VAR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
