I'm not sure I "solved" it, but here's how I got the flashing TX to stop. Again, this is with a K3S, fw 5.50. Nothing attached to the rear panel, especially the ACC connector. LCD TX was constantly flashing.
Went into Config: TX Inh, which was set to Inh=LO. set Inh=Off. Flashing TX stopped, TX functionality restored.. Went back into Config: TX inh, and set it to Inh=LO again. The Flashing TX did NOT re-occur. TX functions. Seems like there was some sort of TX Inh latch state that was cleared by turning TX Inh off or on. Re-cabling the K3S, and no problems so far -- Our ACC cable has a 1K resistor to +5v on pin 10 (tx_inh). That is now being obeyed again. -Brian N9ADG ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
