I will do that. I do have pin 8 shorted to ground through another rs-232 port and that is for my remoting my K3 as a remote. I use the K3/0 mini a lot when I travel and other people do also. I will look at the pin 8 arrangement.
Jerry -----Original Message----- From: Don Wilhelm [mailto:[email protected]] Sent: Monday, November 21, 2016 10:05 AM To: Guy Olinger K2AV; Jerry; [email protected] Subject: Re: [Elecraft] k3 being turn on when N1MM is activated Jerry and Guy, The connector pin problem does not usually manifest itself as something "extra" happening, but something that does not work. I would suggest first unplugging everything except power and a coax to a dummy load. Make sure the K3 operates correctly - plug mic or paddles or key in one at a time to make checks on them. Then connect the RS-232 cable and run N1MM to see if that now behaves normally. Lastly, plug in the AUX I/O cable and see what happens. I would suggest that there is something wrong with the AUX I/O cable - shorting pin 8 to ground. 73, Don W3FPR On 11/21/2016 9:50 AM, Guy Olinger K2AV wrote: > > I'd like to see W3FPR's take on your wimps, if that sounds like the > pin problem to him. > > What's the serial number on your K3? > > 73, Guy K2AV > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
