Hi guys,
I'm having some tough time installing the K3AUDPROTMDKT assembly on
the main board of my K3.
As for every upgrade, I am following the instructions. I removed the two
old electrolytic caps in a few seconds, it was easy and quick.
But installing the new tiny board, as easy as it seems, is just a
different matter. I was able to remove almost all of the remaining
solder, but the pass-thru holes just remain closed with some solder. I
tried with some solder wick but to no avail.
In addition, the pass-thru holes are so small that I don't have any tool
that I can use to try to open those holes while heating the board with
my soldering iron.
I tried to align the 4 legs of the assembly but -of course- pushing them
through the holes is not easy, as they bend as soon as I apply a minimum
force.
Did anyone of you already perform this upgrade? Any tips for me? :)
Thanks, 73
Fabio
IZ4AFW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
