My current setup is K3S, P3, KPA500, KAT500 I recently replaced my K3 with the K3S. I was able to run all the utilities with no problem when I had the K3. Now, the K3S and P3 utilities are fine. But not so withe the KAT and KPA ones. Both take several minutes to come up and run.
KAT500 utility: can’t connect (KAT500 not responding) KPA500 utility: connects at 38400 no problem but no info shows in the operate tab. firmware N/A. I try to load firmware and it fails. I tried to force a load (per the manual) with no luck. More info: The K3 is set to USB. The computer is an Apple mac mini with the latest OS. I’ve refreshed the ports before trying to connect. I’ve tried rebooting, unplugging and replugging the USB cables. I’ve checked all the cable connections. Note that all units are operating OK except: On 6 meters, the KPA faults when trying to run more than 200 watts. It used to work fine when I had a K3 driving it. Any suggestions? TNX and 73, Carl Yaffey K8NU Recording studio. [email protected] 614 268 6353, Columbus OH http://www.carl-yaffey.com http://www.grassahol.com http://www.bluesswing.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
