I have had no luck in trying a variety of combinations using the Unlink VFO, Split and Sub Band commands in the Macro. I know wonder if you can not create a macro that sends VFO A to one band/frequency and VFO B to another band/Frequency?
I am hoping that someone from Elecraft who is responsible for the Macro's can help here before I spend too much more time on this project. Thanks, Irwin KD3TB On Mon, Dec 12, 2016 at 6:44 PM, Irwin Darack <[email protected]> wrote: > > On Mon, Dec 12, 2016 at 5:22 PM Don Wilhelm <[email protected]> > wrote: > >> Irwin, >> Thanks, Irwin >> >> >> My guess is that you do not have VFO IND turned ON in the menu. >> >> You are trying to set the VFOs to two different bands and that requires >> >> VFO INDependent. See page 37 of the K3 manual for full disclosure. >> >> >> >> 73, >> >> Don W3FPR >> >> >> >> On 12/12/2016 5:07 PM, Irwin Darack wrote: >> >> > I would like to write a WWV Macro that sends VFO A = 20 Mhz and VFO B = >> 15 >> >> > Mhz. >> >> > >> >> > This sends VFO A to 20 Mhz: FA00020000000;MD5;FB00015000000;BW0300; >> >> > But does not send VFO B to 15 Mhz >> >> > >> >> > What am I doing wrong here? >> >> > >> >> > Thanks, >> >> > >> >> -- Irwin KD3TB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
