I've been using Mike t on a Dell e4200. I seem to recall is wa the 32bit compatibility lib's. Elecraft's SW is built ( if I recall) as 32bit apps.
Will ping you seperately offline for some questions. Thanks Niel WA7SSA Sent from my iPhone > On Dec 13, 2016, at 17:53, James Bennett <[email protected]> wrote: > > I’ve been using my KX3 connected to a Raspberry Pi 3 for quite some time, > using CQRlog for logging, FLDIGI for PSK31, and recently, WXJT-X rc3 for JT9 > and JT65. I’d like to load the most current firmware into the KX3 so I can > get the full 15 watts out. I downloaded and un-tar’d the KX3 Utility from the > Elecraft web site. So - now what? If I click on the “kx3util” executable, > nothing happens. What is the secret procedure to get this going? I am using > the Raspian Jessie (Debian Linux) OS on this RPi. > > Thanks, Jim / W6JHB > Folsom, CA > > “What’s the difference between a carpenter and a woodworker? About 1/8 inch!" > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
