Well, it's built! KSB2 and KIO2 installed and run fine. Only one problem so far - it's deaf on 10 & 12m. It's probably the LP or BP filters, but I'm not entirely sure.
I tried the transmitter alignment on these two bands and couldn't get any more than 0.7 watts on the power display before the Hi-Cur warning came up. I had a very close look at all the soldered connections around the K10 relay and re-did them. I also checked the continuity of L21 & L22. I then repeated the TX alignment and the power display got beyond 2 watts without the Hi-Cur warning. Only problem: the power meter on my ATU didn't register anything. Signal tracing is probably the best way of getting at a solution, but I don't have access to a signal generator. I would appreciate any help. 73 Bob 2M0KDZ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
