I found the connections in the KXPA100 manual.
On 12/28/16 1:43 AM, Bob Nielsen wrote:
I'm planning on using my KX2 to drive an amplifier other than the
KXPA100. What type of 2.5 mm connector is needed to interface with
the KX2ACBL cable for the amp keying connection? It should only
require tip and shield but I wanted to make sure before I fab a cable
to go to my amp.
Bob, N7XY
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
