Jim,
JT is no different than any other soundcard data mode. You should be
following the data mode setup instructions in the KX3 manual rather than
the information on the internet which is generic for common transceivers
which control power output differently than the Elecraft gear.
Are you using DATA A mode? If not, you should be. Yes, it is the same
as USB, but with the compression and TX EQ automatically turned off.
Are you driving the ALC meter to 4 bars solid with the 5th bar flashing?
That is the "No ALC" point for the K3/K3S/KX3 and KX2.
Inadequate audio drive will cause the problems that you are experiencing.
73,
Don W3FPR
On 12/29/2016 9:17 AM, James Rodenkirch wrote:
Problem: I can turn on the KX3, start WSJT X 1.6 and commence decoding and
making QSOs.
However, if I change to a different band, I can't make QSOs on that band or go
back to the original band and make Qs.
Adjusting ALC on the new band works...power out is the same, etc.
Is there some magical "order of events" I'm not following?
I use Dimension 4 time sync.
Thoughts?? If you are knowledgeable on JT ops and system setup, we can take the
conversation off line...
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
