Ron,
No. Pin 6 is NOT bias, but a source of 8 volts.
Bias to the microphone is applied through a resistor, not directly from
a voltage source.
All you need to do is turn BIAS on in the MIC SEL menu. See the K3
manual for the button to tap to toggle the bias setting.
73,
Don W3FPR
On 1/1/2017 7:09 PM, Ron Manfredi wrote:
Thanks, Don. I was thinking along those lines, but I wasn't sure
about the getting bias from the K3. On the Foster plug I am wiring,
should pin 6 (bias) be connected to pin 1 to supply bias?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
