Hi Mike,
Thanks for pointing this out. I did try both bracket characters anyway,
though. I did solve my problem, though. After searching the archives, I
found that one may need to send repeated bracket commands to the W2. I
tried this and it worked! I was able to set my SWR trip point where I
wanted it, at 3.5:1.
73,
Chuck NI0C
On 1/5/2017 10:06 PM, Michael Chowning wrote:
Chuck,
Do you realize you are using two different bracket characters?
Mike, N8TTR
Sorry, I forgot my callsign in the earlier reply.
On Jan 5, 2017, at 10:14 PM, Chuck Guenther <[email protected]> wrote:
I just fired up a new W2 wattmeter, and it seems to be working ok, except that
I can't seem to adjust the SWR alarm..
I'm using the W2 utility version 1.3.2.27 and my W2 firmware is version 1.00. I have the PTT keying cables
connected to the W2, and am trying to set the SWR trip point that will open the amplifier keying connection.
On p. 8 of the version D2 manual it says I can toggle the alarm on / off by sending the character
"a" to the W2. This seems to be working okay in that I get the expected responses "a1,"
and "a0."
The manual does not specify what the factory default trip point is. It does indicate that I can
move the trip point up or down by send the bracket characters "}" and "[" to
the W2, and that the response will be a number with an implied decimal point. But all I get is 00
in response.
What am I doing wrong? This is very confusing.
TNX & 73,
Chuck Guenther NI0C
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
