Unfortunately you can't use that Config menu directly in a macro to execute with a KPod switch. You could assign it to a PF key and then make a macro that holds that key and then have the KPod execute the macro.
Fred ________________________________ From: Elecraft <[email protected]> on behalf of Joe Subich, W4TV <[email protected]> Sent: Monday, January 16, 2017 3:20 PM To: [email protected] Subject: Re: [Elecraft] K-Pod question On 1/16/2017 11:44 AM, Dave Fugleberg wrote: > I experimented a bit with the method suggested by Fred, using VFO-B > to 'mark' the next signal up the band, and then using A/B to 'jump' > to it. That works, but of course after each 'jump', VFO-B is at the > frequency of the previous QSO. The K3 contains CONFIG:FUNCTION VFO B->A by assigning that function to one of the PF keys, you could use the PF key instead of A/B and avoid the "extra" twiddling of VFO B <G>. 73, ... Joe, W4TV ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
