To don and all others,
I didnt even have to call or mail K3support but I have the response
already. I have reloaded the firmware now on MC 5.56 the DSP is the
same but got reloaded anyway. The problem would seem to be overwork of
the CPU and this seems to fit with my recollection that it only seems to
occur when I have the pc connected. The response from Gary was:-
*****
That error can occur if there are a lot of things going on at the same
time, such as CAT control is being used with a computer and NR or NB are
enabled. It is a report of excessive traffic to/from the K3 MCU.
Try turning things off that are not absolutely necessary, and/or reduce
the polling interval between the PC and the K3.
*****
My thanks to all who replied especially K3support i.e. Eric for
forwarding the mail and Gary and Don for there appropriate responses.
73 de Tony G6GLP
On 18/01/2017 00:54, Don Wilhelm wrote:
Tony,
ERR DSE says that there was a missing echo from a DSP command - see
page 68 in the K3 manual. The first level of "fix" is to reload the
DSP1 (and DSP2 firmware if applicable).
If the problem continues, yes, contact K3support for further assistance.
73,
Don W3FPR
On 1/17/2017 2:22 PM, Tony G6GLP wrote:
Hi All,
Some weeks ago now I installed the 5.54 MCU beta to use with the K-POD I
have not had any problems until the last couple of days when I
intermittently get a ERR DSE E 04004C.
What does the E 04004C mean?
Factual answers please or do I have to contact K3support?
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2016.0.7996 / Virus Database: 4749/13789 - Release Date:
01/17/17
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
