Never mind … Apparently it was just some garbage in VFO A. VFO B was on 144.00 where it should have been. A swap and copy of VFOs fixed the problem.
> On Feb 3, 2017, at 3:37 PM, GRANT YOUNGMAN <[email protected]> wrote: > > Before I call tech support, thought I’d try here. > > Just installed in the 2M module in my KX3. I’m on the latest firmware rev. > Gone over the setup instructions several times, and the parameters are all > set properly — enabled, 50 Mhz IF, in the band map, etc. > > When I go to the 2M band, the display comes up 122.000.00 ????? > > Anyone have an idea? > > Thanks ... > Grant NQ5T > K3 #2091, KX3 #8342 > > > Grant NQ5T K3 #2091, KX3 #8342 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
