tl:dr I like to build things. Getting all the components
assembled in a kit is a wonderful step forward toward the fun part.
I have built several kits with SMD components using just a
temperature controlled soldering station. I think I could get by
with a cheap Radio Shack soldering iron, but I certainly don't
want to. (I like automatic spark advance in my car as well.)
The basic approach is to tin the pads on the board with solder
and clean things up so there are no bridges. Solder one
end/corner of the device and adjust it so it lines up with all
pads. Then go and solder the rest of the pads. This technique
works well with 8 pin devices. I would be in unknown territory
soldering a 400 pin grid array device. :-)
I bought a hot air rework device from SparkFun
<https://www.sparkfun.com/products/10706> for $115 which I use
when I have to remove a SMD component. The video on the page is
a good introduction to removing SMD components.
I will note in passing that the mantle of electronic
construction has moved from the ham community to the builder
community. Their suppliers are now the best place to learn how
to deal with modern electronic components.
73 Bill AE6JV
On 2/13/17 at 9:57 AM, gthorn...@thorntonmostullaw.com (George
Thornton) wrote:
To work with miniaturized surface mount components you need
specialized equipment and specialized skills.
-----------------------------------------------------------------------
Bill Frantz | Security is like Government | Periwinkle
(408)356-8506 | services. The market doesn't | 16345
Englewood Ave
www.pwpconsult.com | want to pay for them. | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
