I could use someone's help - to understand the "resistance" measurement values, at the end of each PCB's completion in manual. I tried making readings with an analog VM and got values too small for some of them.
At a K2 builder's recommendation - I bought an auto-ranging DVM. In measuring resistances for Control Board, (page 21 table). On a few Control Board measurements, I'm getting MUCH higher resistances than table indicates: U6 pin 13 supposed to be > 100k got INFINITE U6 pin 14 supposed to be > 100k got INFINITE U6 pin 29 & 30 to be > 70k got 85k U8 pin 2 to be > 100k got 6.6meg U8 pin 15 & 16 to be > 100k got INFINITE The INFINITE measurements I got for a few of the IC pins - were right up there, like an "open"? I don't know how to interupt this with a DVM? Do these readings sound reasonable? Thanks, 73's Fred N3CSY __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
