Hi Paul,
It's just a matter of adjusting the SensorCal menu setting until the
power reads the same as the device used for the calibration. Of course,
that assumes the calibration device is more accurate than the P3. :=)
The nominal calibration value is 500. The intent was to make it
correspond to the same value as in a W2, but the match is not perfect.
For one thing, the P3 uses a more-sophisticated algorithm to match the
diode detector nonlinearity than the W2.
Alan N1AL
On 03/06/2017 08:56 AM, paul ecker via Elecraft wrote:
Alan - is there any documentation available on the procedure for calibrating
the Tx Monitor?
73Paul
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to n...@sonic.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
