Using band data mode, I've simultaneously driven both the KPA500 and a Top Ten Devices band decoder from a single K3 with no problems.
73, Bob, N6TV On Fri, Mar 10, 2017 at 2:38 PM, NOEL POULIN <[email protected]> wrote: > Hi to all, > I am on the way to connect a Bandpasser2 (band data mode) on a K3s. > Later I would like also to connect a band decoder on the same radio to > switch coaxial stubs. > I wonder if the K3s can handle more than one device connected to the Band > Data signals. > I suppose that Elecraft band output is probably designed to drive one > decoder and this decoder is designed with current maximums for each port. > I would appreciate comments and good tips about that fact... > Thanks > Noel > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
