I'm using the PR6-10 on my K3 (SN4043) and it helps 10m and 6m Rx,
immensely. I also have a ARR 6m gasfet preamp mounted on the 6m
tower for eme and use DIGIOUT-1 to select either preamp with the ARR
on the bypass connector of the PR6-10.
What I got from reading of the original problem was that there was
insufficient gain in the K3 Rx chain at high-end frequencies to
provide adequate sensitivity, so the preamp mainly adds gain to the
chain. Fact that the NF is a little lower does not hurt if you are
in a low noise environ.
On 6m-eme local band noise floor is the prime limit on MDS, other
than needing more antenna gain (single yagi 13-dBi). 15 dBi is
considered the minimum for realistic eme reception. That seems to be
my circumstance where other stations see my 1000w long before I see
them (I have to use ground-gain enhancement to see eme).
73, Ed - KL7UW
http://www.kl7uw.com
Dubus-NA Business mail:
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
