Brian,
The hole was "supposed" to have been enlarged at the factory.
Since yours was not, it is easy to enlarge. Just take a slender knife
blade and carve off a couple of 'slices' around the inside of the hole.
The ones I have had to do take two 'slices'.
73,
Don W3FPR
On 3/16/2017 1:57 AM, Brian Moran via Elecraft wrote:
I'm in the middle of assembling a K1, and have gotten to the front panel final
assembly.
The Potentiometer (type labeled 1-2-3) that I have has a threaded shaft that is
too large of diameter to fit the K1's front panel. What's the best way to
enlarge the hole to preserve the nice new paint?Or is there something else that
I'm missing? I have Googled for this, however nothing in the first page of
results seems to mention this issue.Thanks,
Brian N9ADG
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
