Terry,
Open the soundcard controls for the USB CODEC in your computer and
increase the "Speaker" or Line Out slider.
73,
Don W3FPR
On 3/20/2017 10:57 AM, Terry Schieler wrote:
Don wrote,
<"3) Audio levels - ignore the internet advice to adjust the power with the audio level. Adjust
the audio to illuminate 4 bars solid on the ALC meter with the 5th bar flashing. This is the "NO
ALC" point for these Elecraft transceivers - the first 4 bars are present to allow you to properly
adjust the audio. Once adjusted, you should not have to change it unless something changes it in the
computer.">
Thanks for the particularly timely reply, Don. I spent the past weekend trying to get
my K3S set up for RTTY with MMTTY. My old K3 (474) worked just fine for years. Using
Data A, AFSK, 45 baud, I can cleanly copy RTTY and Transmit via VOX, but, for the life of
me, I cannot get the ALC set to "4 bars solid with the 5th bar flashing". I
can get it to set to 3 bars solid or 5 bars solid but nothing in between, no matter how
sensitive I try to be. Seems I recall someone else with this exact issue on her a few
weeks ago. I have spent this morning trying to find that post as I'm pretty sure his
problem was solved. I am setting the ALC via the Mic (Line) Gain. I checked that Data A
had reduced Compression to ZERO and TX EQ flat. Any suggestions?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
