Good advice. Because I only have one antenna I have antenna 2 disabled after figuring out the procedure in the utility and programming guide and if I ever sell the amplifier I will need to remember to tell the buyer and set it back to original if they wish.
Dave W7VM On Tue, Mar 21, 2017 at 6:16 AM, Don Wilhelm <[email protected]> wrote: > Thaire, > > Check to make sure PA MODE in the KX3 is set to ON. > If still a problem, contact support. > > 73, > Don W3FPR > > > On 3/21/2017 8:43 AM, Thaire Bryant wrote: > >> I am on Nevis, NA-104, with KX3 es KXPA100. >> >> Amp will not switch antennas either through KX3 or directly on amp. Any >> suggestions? >> >> Tsk es 73 >> Thaire. W2APF/V47JR >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
