Hello friends,
i recently build my k2#5426 and it works amazingly fine. But now i run
into some trouble with my external tuner: when connected, i get this
info080 message during power-up and the KAT100 wont start. Inside my K2
the KAF, the NB, a kio and the ssb-adapter are installed and work
perfectly. Firmware should be the last possible release, i got my kits
just three weeks ago.
Of course I searched the eMail list but didnt find really a solution to
my problem.
What i already did: i checked both my K2 and my KAT100 again carefully,
all ICs etc are correct installed; i tried to connect them directly via
a short 10pin flat-ribbon cable between P4/control board and P4/KAT100
rf board; i checked the AUX-BUS connection between the K2 MCU and the
KAT100 MCU. When I am disconnecting the KAT everything works fine again;
when i remove the MCU from its socket in the KAT no error appears. -So I
am thinking that the problem must be somewhere in the auxbus
communication between the rig and the tuner, but because of the fact
that the K2 alone runs flawless with all the modules installed i would
rather search the bug inside the kat.
Maybe anyone here outside does have an idea whereand how i should
proceed with my troubleshooting? Might it be possible that the MCU
inside the tuner could be defective and i should order a replacement?
-Any hints/ideas are warmly appreciated,
greets from cologne,
--
Gruss! & 73 de Rolf Dohmen, DL1KJ
Dohmen EDV&Telekommunikation * Dammstr.13 * 50259 Pulheim
Tel:02238/9638-96 Fax:-99 Mobil:0172/2719098 mailto:[EMAIL PROTECTED]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
