I got my second KAT500 tuner to use with my new backup rig and while setting up and testing and tuning with my two different antennas I made a mistake.
I first observed the results displayed on the utility program operate page where the tuned SWR was 1:1 and the bypass SWR was something like 54:1. I immediately realized that something was not right and discovered that my coax cable was not switched to the antenna but rather my dummy load but the cable to the dummy load was disconnected (because I was moving things around). OK, fixed that little problem but I was curious about the behavior when the KAT500 tuner is faced with an impossible match. Does it give up? I assume it gives up but then I didn’t see anything to indicate that the tuning operation gave up. In fact, it seemed like it found a tuned LC solution but one that was matched with a bypass of 54:1. My first question: If KAT500 fails to find a valid solution does it report an error. I ask this because at times I have had red LED lights flashing on a failed tune but I did not have one this time. I am wondering if I missed the error report on the utility program. My second question: Is it possible that the KAT500 did resolve a tuned LC solution with basically 6 feet of coaxial cable unconnected with anything? Thanks, 73, phil, K7PEH ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
