When I ordered my K2 (end of January) it came in with the old style knob not the one that was in the Errata sheet (same style as the KX3).
After a series of calls and e-mails I finally got Elecraft to send the knob only to find that it does not fit correctly as the encoder shaft is too long so it sticks out from the front panel and does not engage on the felt washer. Additionally the knob is also too large (diameter in the rear where it flairs out so it it did engage the felt washer it would rub on the Display bezel. So my question is to those who recently got a K2 (NOT the KX2). Did you receive a KX3 style Knob as per the Errata Sheet and if so does it fit correctly? Thank you . ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
