I do this now. The memory saved values for power level are both for use with the KPA500 off (standby) and on (off standby). So, I have two saved memory values for power level for the K3 for each condition (amp on, amp off).
73, phil, K7PEH P.S. besides, I would hate to have the KPA500 reset my power level just because it is on. I may not always want the same drive with the amp. > On Apr 21, 2017, at 4:45 PM, Marvin Wheeler <[email protected]> wrote: > > > > Somewhere reading the information about the new KPA1500 I read that if the > new amp was powered on it would cause the K3/K3S to automatically lower to > drive the amp. Can or will this feature be added to the KPA500? I would be a > welcome addition in my opinion. > > > > Marv - KG7V > > > > --- > This email has been checked for viruses by Avast antivirus software. > https://www.avast.com/antivirus > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
