I would cut a few pieces of 1/4 inch plywood and cover it with black
fabric (contact cement, etc.). Just put the pieces between the gear
that need contact protection.
I do not personally have the problem, so this is just a suggestion for
those who do. If you normally use the tilt stand, cut the plywood so it
is shaped to sit on the desk/shelf and the top is angled the same as the
top of the equipment. I would think the top of the plywood separator
should be a bit below the top of the equipment.
Just an idea, implementation is left to "the student".
73,
Don W3FPR
On 4/22/2017 6:02 PM, Bill Johnson wrote:
How about a small block under the soft handle? The handle would then easily
protect another piece of equipment.
73,
Bill
K9YEQ
-----Original Message-----
From: Elecraft [mailto:[email protected]] On Behalf Of Clay
Autery
Sent: Saturday, April 22, 2017 1:12 PM
To: Erik Basilier <[email protected]>; [email protected]
Subject: Re: [Elecraft] FW: Handles and feet
I have given a "proper" spacing/protecting engineering solution serious thought
on a number of occasions.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
