If that were to happen then adding a second 15-way connector at the same time to said module to allow two K3/K3s to drive the one amp through each respective antenna input and matched output would start this amp towards the "basic" SO2R path. From there a smart 2x6 antenna switching unit some well designed BPF filters and your well on your way. The rest of the magic is then just firmware (says he that writes said firmware every day) within the upgraded processor the KPA1500 has been blessed with.
I'm fingers crossed.. 73 Matthew VK5ZM On 26 April 2017 at 22:37, Thomas Donohue <[email protected]> wrote: > Hi to all: > > Wayne or Eric. Are there any plans or thoughts about adding a second RF > input to the amp, similar to what the Yaesu VL-1000 has? > > Best 73, > Tom/W1QU > > > Sent from my iPad > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
