Bill,
That sounds like what can happen if the nut(s) on the encoder shaft
bearing are not tight.
73,
Don W3FPR
On 5/5/2017 6:47 AM, Bill W4ZV wrote:
I recently bought a relatively new K3 (#8641). In the process of adjusting
the Main VFO drag, I noticed the shaft has some minor (few mm?) slippage
(perpendicular to the front panel). Is this normal on recent K3 units or is
it a defective encoder?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
