Roney, If it is an auto-ranging meter, it is okay. 1 just means open, which is greater than 100k ohms. If it is not an auto-ranging meter, make sure you select a range that will measure at least up to 100k ohms. Again, 1 would be okay.
73, Art WB8ENE On Mon, May 22, 2017 at 9:13 AM, roney <[email protected]> wrote: > Hello, I'm just building my first K1. > > Everything is going right, I had already build the filter board, the front > panel, and now in main board. > > I have a question about resistance checks using DMM: > > - Every time when the manual says that in some point the resistance must be > > 100K, my multimeter shows 1, just like there was no resistance. Is that > right ? > > For all other resistance checks in specific values or ranges, it's working > as expected. > > I just need to solve this doubt in order to proceed. > (now I'm on page 29 from manual) > > Thanks and 73 > Roney Monte (PY1ZB) > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
