Hello Don, thanks for the answer. Maybe i did a wrong explanation and the last lines made a bit of confusion. I was intended to say that is normal that when you are in CW, when you press the RF-/ALC button nothing happen and you get only a "BUP-TONE" back !
The problem is the during transmission the SMETER seems dead and doesn't show the RF power output, but in reception the smeter is working correctly signing the segnal streght. We can't understand what is happening. Two days ago, everything was working fine. Thanks a lot, Ciao, Graziano IW2NOY > Il 22 maggio 2017 alle 22.11 Don Wilhelm <[email protected]> ha scritto: > > > Graziano, > > Does the DISPLAY button work normally? If so, there is no problem with > the button itself. > The difference between a tap and a hold is determined by the MCU. > > 73, > Don W3FPR > > On 5/22/2017 6:13 AM, Graziano Roccon wrote: > > Hello, > > > > a friend of mine have an Elecraft K2, always working perfectly. > > Yesterday, without any apparently motivation, the smeter stop to show RF > > Power level during transmit. > > > > The K2 emit power without problem and the external wattmeter show the right > > power. > > The smeter is working in RX, but not working in TX. > > The K2 is mainly used in CW, so the switch button RF/ALC is not working. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
