Anthony,
I suspect you have the 'new' knob. The one I am referring to is the
same one used on the KX3 and has a rubber ring.
The knob previously used on the K2 has become unavailable.
If so, contact support and request 2 additional felt washers and stack them.
I have not yet had a chance to check out a K2 with the new encoder and
that new knob.
73,
Don W3FPR
On 5/27/2017 2:17 PM, Anthony Clare wrote:
Hello:
I am well into the assembly of K2 #7734 and ran into a snag. The vfo knob will
not come close enough to the felt washer to create any friction. I cannot see
where I would have done anything wrong during assembly.
Otherwise, the new encoder feels really good. I just need to stop the
freewheeling of the knob when I let go of it. I have some ideas in my head,
but I wanted to see what you guys have done first.
Any ideas?
Anthony
n3kcb
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
