Bob,
If you bought it new, it had that tuneup before it left the factory -
any problems in the first year should be taken care of under warranty.
If you do have problems, the first course of action is to contact
Elecraft support.
If you bought it used, and you want it checked out at the factory the
same as would be done if it were new, you will need an RSA to send it
in. To start that process, contact [email protected]. Wait until
you have the RSA number and form and instructions before sending it.
I don't know what the normal time to check it out will be, but my guess
is about 1.5 hours at $99 per hour plus shipping.
It will come back to you having been reset to factory defaults with
firmware updated, so if you have established some favorite setting like
TX/RX EQ or AGC parameters, etc. Write your settings down before
sending. In this particular case I would suggest not relying on a saved
configuration file.
73,
Don W3FPR
On 5/31/2017 1:56 PM, Bob Jonas wrote:
My KX3 is my first (and only) Elecraft and I am curious about the procedure
to have have it sent in have have them do a look over of the rig.
I've had had it for a few months and would just to get a clean bill of
health.
Any comments on the procedure?
Cost?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
