Yes Many options
You can use an rs232 cable connected to a rs232/USB adapter on your desk computer. You can do IP, but you'll need a computer at the amp end and the operator end and use a LAN in between. You can also do serial over ip to your computer at the operator end with a rpi running ser2net or a serial over ip interface box. I control mine from a hundred miles away. Mike va3mw > On Jun 7, 2017, at 10:08 AM, "[email protected]" <[email protected]> wrote: > > Hi, Can a KPA500 be operated remotely, for example, in a different room from > the operator? > Specifically would such remote operations be possible via USB cable or > additional hardware, > or even via IP using additional hardware on the amplifier side. > The need is to be able to switch remotely between standby and oper. > Ultimately this might > allow both a flex radio and KPA500 to be separated from the operator. > Thanks very much, > Jack > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
