Thanks to the two guys who responded to my question today concerning the VFO
pot. The pot was wired to the board incorrectly. The markings on the pot
are a little confusing, but when I looked closely at the diagram in the
Elecraft manual, I found that I had not followed their instructions exactly.
So, that problem is fixed and the receiver alignment is complete. It was
a bit of a thrill to actually hear signals on the air and know the receiver
is working correctly. I look forward to having it finished and one the air.
Thanks again.
73,
Wes W1LIC
_________________________________________________________________
Dont just search. Find. Check out the new MSN Search!
http://search.msn.click-url.com/go/onm00200636ave/direct/01/
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
