AFAIK you can't use MP for the RP, FP controls.
You would need to select the MIC menu using MN053 then a series of DN and UP
commands to move through the menu parameters.
MN053;DN;DN;MN255; will set Front Panel
MN053;DN;DN;UP;MN255; will set Rear Panel
MN053;DN;DN;UP;UP;MN255; will set Line In
73,
Alan. G4GNX
-----Original Message-----
From: i5nph
Sent: Sunday, June 25, 2017 11:37 AM
To: [email protected]
Subject: [Elecraft] Macro to switch Microphone input
I am using firmware 05.57 and I am tryng to use the command MP to write
macro
to switch Microphone from LINEIN and FPH.
But I get response MP?
This macro I know was working before.....it is very important because I work
JT65 and I would like to switch the way of the audio input (LINEIN and FPH)
without be forced to go to Menu.
Hope in some help
Thanks in advance
73
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
