This is a repeat of an email that I sent to Terry and the list, and which didn't make it to the list last week, so am trying again after some changes have made by the powers that be.
Terry, It appears that Fldigi uses audio keying rather than real CW. So you will use the same setup that you have for other Digital modes within Fldigi and your Signalink. Details are at: http://www.w1hkj.com/FldigiHelp-3.21/html/cw_configuration_page.html 73 from David GM4JJJ > On 30 Jun 2017, at 04:26, Terry Brown <[email protected]> wrote: > > I have a KX3 connected to a Signalink and Fldigi. It seems to work fine for > all the digital modes. I can use it to decode CW, but have never sent CW. > I clicked on the CQ button and all that happened was that my transmitter > went into transmit mode, but nothing was transmitted. If I put the KX3 in > LSB it would transmit cw fine, but was always off frequency by the amount of > my sidetone. > > > > Will fldigi send CW correctly in cw mode on the KX3? If so, what am I doing > wrong. > > > > Thanks, > > > > Terry > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
