Thanks, Don, I will give that a try. I am using the USB cable to my Win 10 PC. It installed COMM 8 and COMM 9. I must not have the PTT settings right, yet. I can't get it to key the radio. Do you know what those should be?
73, Dave, K8AJA On Jul 6, 2017 6:44 PM, "Don Wilhelm" <[email protected]> wrote: > Dave, > > CW via KY commands is quite different than the soundcard data modes (PSK, > RTTY, WSJT-X). > > For those DATA modes, you need to put the K3S into DATA A mode. > Then set the MIC SEL in the K3S to LINE IN. > The soundcard selected should be the CODEC in the K3S. > Make certain there is nothing plugged into the LINE IN jack on the K3S - > that takes precedence over the internal soundcard output. > > Once you have the correct soundcard set up in the computer, initially > leave the K3S LINE OUT menu set to the default of 010. You can adjust it > later if you need fine adjustment. > Set the soundcard to use LINE IN instead of MIC if you can. Then set the > computer volume sliders so you get a decent waterfall display. > > On the transmit side of things, initially set the computer LINE OUT (or > SPKR if you can't get LINE OUT) to about 50%. Put the K3S into TX TEST > mode so you do not produce RF. > Do a transmit from the digital application. > While transmitting, adjust the K3S MIC GAIN (Actually LINE IN gain) to > produce 4 bars solid with the 5th bar flickering on the ALC meter. You may > have to shuffle back and forth between the computer LINE OUT (or SPKR) > slider and the K3S MIC GAIN to achieve that condition. > > Once you have those settings correct, go out of TX TEST and operate. > > Ignore the common internet advice to adjust the power output with the > audio level - it does not work well with Elecraft gear. Adjust the POWER > knob to the desired power output. > > I cannot answer about WSJT-X through HRD, but WSJT-X is "just another > soundcard data mode", and the same things that apply to PSK and RTTY are > applicable to WSJT-X. > > 73, > Don W3FPR > > > On 7/6/2017 6:14 PM, David Needham wrote: > >> Hello, >> >> I am new to the group and just completed my K3S. I have been able to get >> Rig Control to work with my version 6.4.0.633 of Ham Radio Deluxe and CW >> Send/receive on DM780 using CW(KY cmd), but no luck with PSK, RTTY and >> WSJT-X. >> >> Does anyone have the setting to get PSK31 and RTTY to work with DM780? >> >> How about using WSJT-X where the Rig is Ham Radio Deluxe? >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
