You might also want to check the frequency calibration of the P3 (page 31 in the P3 manual). I happen to notice while checking the K3S frequency against WWV and going through K3S calibration, the P3 was off about 250hz (with 600hz sidetone).
Gene N9TF > On July 29, 2017 at 8:10 PM Gene O <[email protected]> wrote: > > > Just discovered when trying to copy a strong CW signal the frequency > seems to offset. I can see the signal on my P3 at say 7024.000 but I > hear the station the strongest at 7025.000. This occurs with either my > 1.0khz or 400hz filter. > > Is there some frequency offset that I may set in error? > > Thanks. Gene, W2BXR > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
