The display on my K2 (S/N 7637) just quit. The backlight is on, but not a single digit component appears.
The rig has been working FB for over a year. Used it today as the alignment receiver for another K2 being built. All was fine when that process started, both rigs worked as they should, and then the display on 7637 just went blank. Illuminated, but blank.. Hard to tell if anything else was affected since without any display information at all I don’t know what the rig is doing or what mode it’s in. Any suggestions about where I should start? Thanks, as always . . . Ted, KN1CBR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
