Bob,
The '--' in the ATU menu means that the KAT2 firmware is not being seen
by the K2 MCU.
Take a good look at the point where the control cable is attached to the
KAT2 control board - look for broken wires.
Do the same for the header that plugs to K2 Control Board P4.
Make certain the header which plugs into K2 Control Board P4 is
installed correctly - the green wire should be at the top.
73,
Don W3FPR
tuner was working fine yesterday and earlier today, and then after one
press of the "Tune" button on the front panel it is no longer functional.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
