Bob, Everything looks good EXCEPT J1 pins 1-7, 9 and 11-14. These should not be zero ohms or near zero ohms. Check your soldering to see if there is excess solder that might be shorting things together - that is the most likely cause. After all, J1 pins 1, 2 and 3 connect only to the AF Gain, so all those should indicate a high resistance to ground (at this point, the AF Gain control should connect to nothing else (see the schematic), and pins 4 and 5 go only over to the mic configuration header position and dead end there because you do not have the header mounted yet.
73, Don W3FPR > -----Original Message----- > > I've reached the resistance checks for the front panel on page 28 of the > manual, and things do not appear to be going well. > > I do have the KSB2 kit, so I have installed the front panel parts > from that > kit, as directed on page 28 of the K2 manual. I've attempted to > inspect for > solder bridges, cold solder joints, and unsoldered components, > but I'm very > much a software guy, and don't have a great deal of confidence in my > inspection abilities. > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
